Clover B14A Hot and Cold Bottled Water Dispenser User Manual

1. መግቢያ

The Clover B14A Hot and Cold Bottled Water Dispenser provides convenient access to refreshing chilled drinking water and piping hot water. Designed for home or office use, this dispenser features hygienic stainless steel tanks and an efficient cooling and heating system. Please read this manual thoroughly before operation to ensure safe and optimal performance.

2. የደህንነት መረጃ

• የኤሌክትሪክ ደህንነት; This appliance operates on 110-120 volts, 50-60 Hz. Ensure the power outlet is properly grounded. Do not use with damaged cords or plugs.
• የሙቅ ውሃ ደህንነት; The hot water temperature reaches approximately 185°F (85°C). Exercise extreme caution when dispensing hot water to prevent burns. A safety switch is provided for the hot water dispenser.
• የልጆች ደህንነት; Always engage the hot water safety switch when children are present to prevent accidental dispensing of hot water.
• አቀማመጥ፡- Place the dispenser on a flat, stable surface away from direct sunlight, heat sources, and areas with high humidity. Ensure adequate ventilation around the unit.
• የውሃ ጠርሙስ: Use only standard 5-gallon (18.9-liter) water bottles.
• ጥገና፡- ከማጽዳትዎ በፊት ወይም ማንኛውንም ጥገና ከማድረግዎ በፊት ክፍሉን ይንቀሉ.

3. ማዋቀር

1. ማሸግ፡ ማከፋፈያውን ከማሸጊያው በጥንቃቄ ያስወግዱት. ለማንኛውም ጉዳት ይፈትሹ.
2. አቀማመጥ፡- Position the dispenser on a level, sturdy surface. Allow at least 4 inches (10 cm) of clearance from walls for proper ventilation.
3. የሚንጠባጠብ ትሪ ጫን Insert the concealed, lift-out drip tray into its designated slot below the spigots.
4. የመጀመሪያ ጽዳት; Before first use, clean the exterior with a soft, damp ጨርቅ.
5. የውሃ ጠርሙስ መትከል; Remove the protective seal from a new 5-gallon water bottle. Lift the bottle and quickly invert it, placing it firmly onto the bottle support on top of the dispenser. Ensure the bottle is seated correctly to prevent leaks.
6. የፍሳሽ ማስወገጃ ሥርዓት; Before plugging in, dispense at least 1 liter (approximately 4 cups) of water from both the hot and cold spigots to ensure the tanks are filled and to flush any air from the system.
7. መሰካት፥ የኤሌክትሪክ ገመዱን ወደ መሬት ወደ 110-120V የኤሌክትሪክ ሶኬት ይሰኩት።

ምስል 1: ሙሉ view of the Clover B14A water dispenser with a 5-gallon bottle.

4. የአሠራር መመሪያዎች

1. አብራ፡ Once plugged in, the dispenser will begin cooling and heating the water. Allow approximately 15-30 minutes for the water to reach desired temperatures.
2. ቀዝቃዛ ውሃ ማሰራጨት; Place your cup under the cold water spigot (typically blue). Push the lever to dispense cold water. Release the lever to stop.
3. ሙቅ ውሃ ማሰራጨት; Place your cup under the hot water spigot (typically red). To dispense hot water, first push the safety switch (often a red button or lever) and then push the main lever. Release both to stop.
4. ሙቅ ውሃ መቀየሪያ; The hot water function can be turned on or off using the switch located on the back of the unit. Turning it off will prevent the water from heating, saving energy and acting as an additional safety measure.
5. Adjusting Cold Water Temperature: The cold water temperature can be adjusted via a thermostat control, usually located on the back of the unit. It allows for a range of 35.6°F to 53.6°F (2°C to 12°C).

Figure 2: Detail of the hot (red) and cold (blue) water spigots with the hot water safety switch.

5. ጥገና

• የሚንጠባጠብ ትሪ ማፅዳት; The drip tray is removable for easy cleaning. Periodically empty and wash the tray with mild soap and water.
• የውጭ ጽዳት; ውጫዊ ገጽታዎችን ለስላሳ, መamp ጨርቅ. ገላጭ ማጽጃዎችን ወይም ፈሳሾችን አይጠቀሙ.
• መግለጥ: Over time, mineral deposits may accumulate in the hot water tank. Consult the manufacturer's webየሚመከሩ የማስወገጃ ሂደቶችን ለማግኘት የጣቢያ ወይም የደንበኛ ድጋፍ።
• የውሃ ማጠራቀሚያ ማጽዳት; For thorough cleaning of the internal water tanks, it is recommended to contact a qualified service technician.

6. መላ መፈለግ

• የውሃ ማከፋፈያ የለም; Ensure the water bottle is properly seated and not empty. Check if the unit is plugged in and powered on.
• ሙቅ ውሃ የለም Verify the hot water switch on the back of the unit is in the 'ON' position. Check if the thermal reset button (often a small red button on the back) needs to be pressed.
• No Cold Water: Ensure the unit is plugged in and the cold water thermostat is set to a desired temperature.
• መፍሰስ፡ Check the water bottle for cracks or improper seating. Ensure the drip tray is correctly installed.
• ያልተለመደ ድምጽ; The unit is designed for quiet operation. If unusual or excessive noise occurs, ensure the unit is on a level surface and not vibrating against a wall. If noise persists, contact customer support.

7. ዝርዝሮች

• ሞዴል፡ B14A
• ልኬቶች (D x W x H)፦ 12.3" x 12.7" x 37.9" (31.2 ሴሜ x 32.3 ሴሜ x 96.3 ሴሜ)
• ክብደት፡ 32 ፓውንድ (14.5 ኪ.ግ)
• ቀለም፡ Black with Steel side panels
• ጥራዝtage: 110-120 ቪ
• ድግግሞሽ፡ 50-60 Hz
• የሙቅ ውሃ ሙቀት; Approximately 185°F (85°C) (non-adjustable)
• የቀዝቃዛ ውሃ ሙቀት; 35.6°F - 53.6°F (2°C - 12°C) (adjustable)
• Compatible Bottle Sizes: 5 ጋሎን (18.9 ሊት)
• የግንባታ እቃዎች; አይዝጌ ብረት ፣ ፕላስቲክ
• ማረጋገጫዎች፡- CE, NSF, UL, Energy Star Rated
• የመንጠባጠብ ትሪ; Concealed, lift-out design, high impact, durable ABS. Removable, anti-splash grid.

8. ዋስትና እና ድጋፍ

The Clover B14A Hot and Cold Bottled Water Dispenser comes with a የ 1 ዓመት የተወሰነ የአምራች ዋስትና. For warranty claims, technical assistance, or further inquiries, please contact Clover customer support. Keep your purchase receipt as proof of purchase.