COAST HP6 170 Lumen Pure Beam Focusing LED Flashlight Instruction Manual

1. ማዋቀር

1.1 የባትሪ ጭነት

The COAST HP6 flashlight requires two (2) AA batteries for operation. These batteries are typically included with your purchase.

1. የእጅ ባትሪውን ጅራት ክዳን በተቃራኒ ሰዓት አቅጣጫ በማዞር ይክፈቱት።
2. Insert two AA batteries into the battery compartment, ensuring the positive (+) end of each battery faces towards the head of the flashlight.
3. Carefully re-screw the tail cap back onto the flashlight by turning it clockwise until it is securely tightened. Do not overtighten.

Image 1.1: The COAST HP6 LED Flashlight. The tail cap for battery access is located at the rear of the flashlight.

1.2 የመጀመሪያ ምርመራ

Before first use, inspect the flashlight for any visible damage. Ensure all components are securely attached and that the lens is clear.

2. የአሠራር መመሪያዎች

2.1 የመብራት / ማጥፊያ እና ሁነታ ምርጫ

The HP6 features a quick cycle switch located on the tail cap for power control and mode selection.

• To turn the flashlight ON, press the tail switch completely until it clicks.
• To cycle between High (170 lumens) and Low (34 lumens) output modes, lightly press the tail switch without clicking it off.
• To turn the flashlight OFF, press the tail switch completely until it clicks again.

2.2 Pure Beam Focusing Optic System with Fingertip Speed Focus Control

The HP6 allows you to adjust the beam from a broad flood light to a concentrated spot beam.

• To adjust the beam, slide the head of the flashlight forward or backward. Sliding forward typically narrows the beam to a spot, while sliding backward widens it to a flood.
• The Pure Beam Focusing Optic System ensures consistent beam quality without dark rings, providing a clear spot with an outer ring of flood light.

2.3 የቢም መቆለፊያ ስርዓት

Once your desired beam focus is achieved, the Beam Lock System allows you to secure the focus setting.

• To engage the Beam Lock, twist the head of the flashlight slightly after adjusting the focus. This will lock the head in place, preventing accidental changes to the beam pattern.
• To disengage, twist the head in the opposite direction to unlock and allow for further focus adjustments.

3. ጥገና

3.1 ጽዳት

ጥሩ አፈፃፀምን ለመጠበቅ የእጅ ባትሪውን ንፁህ ያድርጉት። ውጫዊውን በለስላሳ፣ d ይጥረጉ።amp ጨርቅ. ገላጭ ማጽጃዎችን ወይም ፈሳሾችን አይጠቀሙ.

3.2 የባትሪ መተካት

Replace batteries when the light output diminishes significantly. Follow the battery installation steps outlined in Section 1.1.

3.3 ማከማቻ

Store the flashlight in a cool, dry place away from direct sunlight. For long-term storage (over 30 days), remove the batteries to prevent leakage and potential damage to the flashlight.

3.4 የውሃ መቋቋም

The HP6 is designed with a rubberized O-ring for water resistance, meeting ANSI/FL1 standards. It is resistant to splashes and light rain but is not intended for submersion in water.

4. መላ መፈለግ

• የእጅ ባትሪ አይበራም
  Ensure batteries are inserted correctly with the positive (+) end facing the head. Check if batteries are depleted and replace them if necessary. Ensure the tail cap is fully tightened.
• የጨለመ ብርሃን ውጤት;
  This typically indicates low battery power. Replace both AA batteries with fresh ones.
• Focus mechanism is stiff or not working smoothly:
  Inspect the sliding head for any dirt or debris that might be obstructing its movement. Clean the area if needed. Avoid forcing the mechanism.

5. ዝርዝሮች

6. የዋስትና መረጃ

The COAST HP6 LED Flashlight is backed by Coast's lifetime guarantee against defects in materials and workmanship. For detailed warranty terms and conditions, please refer to the official Coast webጣቢያ ወይም የደንበኛ ድጋፍን ያግኙ።

7. ድጋፍ

If you encounter any issues not covered in this manual or require further assistance, please contact Coast customer support. Refer to the product packaging or the official Coast webየእውቂያ መረጃ ለማግኘት ጣቢያ.