Streamlight Stinger LED HL 120/DC PB Flashlight

1. መግቢያ

This manual provides detailed instructions for the safe and effective use of your Streamlight Stinger LED HL 120/DC PB rechargeable flashlight. Please read all instructions carefully before operating the device.

የደህንነት መረጃ

• በቀጥታ ወደ LED መብራት አይመልከቱ። ኃይለኛው ጨረር ጊዜያዊ የእይታ እክል ሊያስከትል ይችላል።
• ልጆች በማይደርሱበት ቦታ ያስቀምጡ.
• Use only Streamlight approved batteries and charging equipment.
• Do not attempt to disassemble the flashlight head or battery pack.
• Avoid exposing the flashlight to extreme temperatures or corrosive liquids.

Figure 1: Streamlight Stinger LED HL 120/DC PB Flashlight. This image shows the blue tactical flashlight with its distinct head and body design.

2. ማዋቀር

2.1 የመጀመሪያ የባትሪ ኃይል መሙላት

Your Streamlight Stinger LED HL 120/DC PB flashlight comes with a rechargeable NiMH battery. Before first use, fully charge the battery.

1. Connect the charging cord to the charger base and plug it into a suitable power source (120V AC or 12V DC).
2. Insert the flashlight into the charger base. Ensure the charging contacts on the flashlight align with those in the charger.
3. The charging indicator light on the charger will illuminate, typically red, to indicate charging is in progress.
4. Allow approximately 10-12 hours for a full charge if the battery is completely depleted. The indicator light may change color (e.g., green) or turn off when charging is complete, depending on the charger model.

2.2 Battery Installation (if required)

The battery is typically pre-installed. If you need to replace or install the battery:

1. የእጅ ባትሪውን ጅራት ክዳን በተቃራኒ ሰዓት አቅጣጫ በማዞር ይክፈቱት።
2. Insert the NiMH battery with the positive (+) terminal facing towards the head of the flashlight.
3. የጅራቱን ክዳን ደህንነቱ በተጠበቀ ሁኔታ እስኪጣበቅ ድረስ በሰዓት አቅጣጫ መልሰው ይከርክሙት።

3. የአሠራር መመሪያዎች

The Stinger LED HL 120/DC PB features multiple lighting modes controlled by a single push-button switch.

3.1 የመብራት / ማጥፊያ እና ሁነታ ምርጫ

• ለማብራት፡- Press and release the push-button switch. The flashlight will activate in the last used mode (High, Medium, or Low).
• የዑደት ሁነታዎችን ለማስኬድ፦ With the flashlight on, press and release the switch repeatedly within 1.5 seconds to cycle through High, Medium, and Low brightness settings.
• To activate Strobe: From any mode (on or off), press and hold the switch for approximately 2 seconds. Release to turn off strobe.
• ለማጥፋት፡- Press and release the switch when the flashlight has been in a single mode for more than 1.5 seconds.

3.2 Recharging the Flashlight

When the light output diminishes, it indicates the battery needs recharging. Follow the steps in Section 2.1 to recharge the flashlight.

4. ጥገና

4.1 ጽዳት

• Wipe the flashlight body with a damp ጨርቅ. ገላጭ ማጽጃዎችን ወይም ፈሳሾችን አይጠቀሙ.
• Clean the charging contacts periodically with a clean, dry cloth to ensure proper connection.

4.2 የባትሪ እንክብካቤ እና መተካት

• For optimal battery life, avoid fully discharging the battery before recharging.
• If the flashlight will not be used for an extended period, store it with a partial charge and recharge every few months.
• Replace the NiMH battery when its run time significantly decreases. Use only genuine Streamlight replacement batteries.

4.3 ማከማቻ

የእጅ ባትሪውን በቀጥታ ከፀሀይ ብርሀን እና ከከፍተኛ ሙቀት ርቆ በቀዝቃዛና ደረቅ ቦታ ያከማቹ።

5. መላ መፈለግ

ለጋራ ጉዳዮች እና መፍትሄዎቻቸው ከዚህ በታች ያለውን ሰንጠረዥ ይመልከቱ።

6. ዝርዝሮች

7. የዋስትና መረጃ

Streamlight products are known for their quality and durability. For specific warranty details, including coverage period and terms, please refer to the official Streamlight webከግዢዎ ጋር የተካተተውን ጣቢያ ወይም የዋስትና ካርድ። የግዢ ማረጋገጫዎን ለዋስትና ጥያቄዎች ያስቀምጡ።

8. የደንበኛ ድጋፍ

If you have any questions, require technical assistance, or need to report an issue that cannot be resolved using the troubleshooting guide, please contact Streamlight customer support. Visit the official Streamlight website for contact information, including phone numbers and email addresses.